Home

Centrifugal switch - Appliance Repair Forum

by SL8

Can anyone stipulate me with a see in the mind's eye of the guts of a centrifugal switch? This is for a Kenmore and I don’t be acquainted with how old it is but its not new. I see how it works, duh, but it seems counter-clockwise to me. When the motor over speesds the weights move and put up with a lever to move which releases the problems applied to the flexibility in the switch and that opens the pale. But I evaluate the ambit should be closed because if I hop the switch (M1 to M2) everything works. I haven’t changed the stance of any of the wires or anything it neutral stopped working one day. Switch part # 337351 and motor # 695075.

Source: Centrifugal switch - Appliance Repair Forum

Whirlpool/ Kenmore Electric Dryer Door Switch Replacement (part #3406107)

Thisvideo shows raise-by-step instructions on replacing the door switch on Whirlpool, Kenmore, Sears, Maytag, and Amana dryers. Buy part #3406107 ...

How can I check door switch on an inglis washer? The top of the washer seems to be screwed from the inside.?

Nov 20, 2006 by Ti'del | Posted in Cleaning & Laundry

This is a top loading, wonderful format model. The machine stops in mid-cycle sometimes. When I open the lid and shut it softly - nothing. When I let it fall shut down a exclude it starts to run. ?? door switch ?? timer. I tried to pop the top of the washer open to check the door switch, but it seems to be screwed screen from the inside. Unless the newer inglis models have a trick to opening the top, it looks like it is not amenable to open it up.
Thanks!

You have a bad switch or a switch that needs adjusting. The top is not screwed down from the backwards. Take a look at the front of the washer where the top sits on the machine there will be a small crack between the top and the body of the washer, about two inchs from each side on the front there will be two locking clips that clasp the top on, you cant see these clips but if you take a small screw driver or a butter knife you can slide it in between the top and body and push against these clips to discharge them and flip the top back out of the way

How do I remove the door switch in a 95 Toyota Camry?

Jan 16, 2007 by Howard | Posted in Maintenance & Repairs

I have a 95 Camry and the dome fluorescent is intermittent. The dome light flashes on and off if I wiggle on the door switch, behind a rubber cover. I removed the bolt from the switch and cleaned the excuse sediment connection. Still no go. I then removed the rubber cover and remounted the switch. It still is intermittent.

I was going to swap a good switch from one of the back part doors over to the driver side but I can't figure out how to remove the wire from the switch without breaking it. It looks like it is a straight angle quick connect type connector and I tried pulling it straight up but it won't budge. It looks like the ending might have a locking tab on it. I tried putting a small screwdriver blade in the small rectangular hole in the side of the switch and pulled up on the fatal but it still won't budge.

Does anyone know how to remove this wire without destroying it?

See if new swithc comes with a pigtail on it and juts hardwire the correlation and insulate the leads. You may not even have to buy a Toyota switch for this. Perhaps aftermarket will do. If not you can buy the harness plug from them too.

Does it matter which wire goes where on a maytag dryer door switch?

Mar 07, 2007 by lee | Posted in Do It Yourself (DIY)

I changed the door switch on my Maytag Dryer. It had a yellow wire and a pasty wire running to the switch. But I forgot to label where each wire went on the new switch after I removed the old switch then went to the appliance store. Does it matter?

Not at all, it hardly completes a circuit...wire them as you please.