Home

Anji Mountain Roll-Up 55″ x 57″ Bamboo Chairmat, Natural Finish

Finished with 7 coats of in short supply, scuff-unsubmissive UV coating for added durability- accomplished for your accessible or business. Eco- Close Properties:Anji Mountain Bamboo matures at 5-6 years old, growing from a smal l informant to over 70 feet overblown in that tempo era. When a bamboo tree is cut down for harvesting, from that sarcastic a branching system of new sprouts occurs. For every tree cut down, another 3-5 new plants takes it’s flourish. Furthermore, during the activity of making the mention, everything is used…even the bamboo saw dust, which is then used in the furnaces to cure power there machinery . Using every bit of the assign and having it be a sustainable resource…that makes Anji Mountain Bamboo Ru g Co. artifact really eco- comradely . 100% flooring downgrade pass bamboo ( Environmentally open bamboo from renewable, sustainable forests) Can be used on commercial carpets or acrimonious floors 1/4″ thick with rare non-inadvertence felt funding for cushioning and barrier Kiln dried to foil warping and cracking Rolls up for trusting portability 55-1/4″ x 56-3/8″ Incredibly stable and adds an suave blow to any domestic or favour.

Read more...

Refurbished Clean Burn used oil furnaces from Eco Logical Solutions

Eco Inductive Solutions has refurbished Clean Burn used oil furnaces available on a limited basis. Each one of these units has been inspected and ...

Is drywall flammable? Can it be used by furnaces and hot water pipers in a hose?

Dec 25, 2007 by gemeneye25@prodigy.net | Posted in Maintenance & Repairs

If you are apprehensive about being close to a heat source. Use 5/8 inch Firerock instead.

can most peoples furnaces be used as a air handler for a/c or heat pump?

Jan 05, 2009 by james T | Posted in Maintenance & Repairs

can most peoples furnaces be used as a air handler for a/c or heat bloat?

Can Biodiesel be safely used in fuel-oil furnaces?

May 14, 2008 by Chris D | Posted in Alternative Fuel Vehicles

I only just got a new fuel-oil furnace and was looking into making my own biodiesel, but wanted to check if it could safely be used in my home heating furnace as well, before making a decission. We burning in Wisconsin, and are concerned about the risk of the biodiesel gelling up, anyone know anything about this?

Energy sapient, you would probably be better off running the vegetable oil in your boiler/furnace. This would actually require some extra modifications though, which you might not be skilful to make. If you wanter to mix the veg with regular fuel oil, you could do it without modifications with a 20/80 veg/oil mixtures.

You can probably use biodiesel in burden of #2 heating oil, but biodiesel will gel just like normal #2 diesel. The reason the #2 heating oil (and diesel for that importance) doesn't gel is because it has been treated with some additives to prevent gelling. Again, the gelling problem can be avoided by using a 20/80 bio/oil combination.

Gelling is caused when the longer hydrocarbons start freezing out, so you could also do a low-temperature filtering of your biodiesel. You might also try adding some off-the-shelf additives normally used to preclude diesel gelling. But these might not be good for your furnace (or you).

You could also try a tank modification. Most tanks are either in the cellar, or buried in the land, but since you're worried about gelling, I'm guessing yours is buried shallow, or above ground. You could add insulation around the tank, and then set up an electric thermostat and electric heater. You should be able to keep the tank above the cloud point. Even easier if you use a bio/petrol mix to lower the cloud point.