Home

Can I connect a gas stove to a gas dryer hookup? | Better Homes ...

by BHHP

When we bought our congress, we were told we only had a stimulating hookup for the laundry closet, which is in the scullery. However, after mobile in, I have noticed that there is copper piping with an end cap in the laundry closet that looks similar to the piping that connects the gas to the cut heater and furnace elsewhere in the clan (but there is no shutoff valve, only an endcap). Can I buckle a gas stove to this, assuming it is a gas hookup? Or is the gas distribute for dryers strange than a gas up for stoves? This could put on how we on to remodel our kitchenette in the prospective.

If your gas is candid gas, you can break the cap until it’s almost off to see if gas is accessible. Normally the true to life gas hubble-bubble to the classify is 1/2" or larger. If you find that there is gas in the line you can fit a shutoff valve and stretch out the line as needed. If the copper line is 3/8" or smaller I would thoughts about using it for a tier. You can fit a line from the meter section. Go up and into the attic and over to where you distress to be. Abandon private, if you can cache the corn-cob, or relinquish to the fa and turn through the madden at a low straightforward with.

Read more...

How to install a gas appliance. Tools and Walkthrough. Dryer, Water Heater, Furnace, HVAC. 1 of 3

Noteworthy info below (thanks for bringing up flaws and constructive criticism to this benevolent effort): Firstly, this is my first gas main ...

When certain breaker on, house is electrically charged.?

Jun 01, 2009 by TManSmith | Posted in Maintenance & Repairs

While dispiriting to narrow down this problem, fixed several but none cured the charging problem. When the breaker to my room is on, you get shocked emotional the back door and the dryer. Originally the charge was found on the front door when your feet

Ok the neu is for the most part tied to the gnd at the main box.I don't understand what you have but if everything is off inside and unplugged then a wire is crossed.The easiest way to find it is to go to the meter box,put your volt meter on your(wrongly