Home

Checking Your Pressure Switch on a Gas Furnace « Atlanta HVAC

by admin

Ok folks I wanted to parcel something knowledge on checking your apply pressure on switch. Now this is in fact more for my intermediary readers and if you are a utter greenhorn then you might lust after to be leftover finicky with this one. For those of you who are undisturbed with some of the inside parts of a furnace then this video is trustworthy to serve you learn about checking a force redirect. Now in this video they use a gas furnace and anytime you drudgery with a gas furnace you should always keep refuge as your troop one primacy. Now with that said let me break set upright into the video:

So what did you folks about of the video? I consideration it was very linear first and edifying. These are the types of videos that I intended posting because they are meagre, tell and to the signification. Not only that but the info is very correct and there are no security steps that have been skipped. Many times I’ve seen videos where they are explaining how to do something but unfortunately they are doing it injudicious. They might end up with the unerringly results in that case but they will at some feature materialize that their methods are not epidemic and don’t travail in every cover. This is why I try to concealment these videos totally to fabricate reliable that you all get trained the speedily way. Ok that’s all for today. As always say discuss away if you have any questions.

Read more...

Checking the pressure switch on a gas furnace

Measuring ohms on an energized 80% gas furnace

my gas furnace hums but will not stay running is it the transformer everything else is trying to work?

Mar 17, 2008 by Mike | Posted in Maintenance & Repairs

My gas furnace will turn on to run for a few minutes then locked up off the motor will hum like it wants to start but then cut off could lse it be the transformer . Everything else trys to run but the unit just cuts off.

To discountenance shoot the transformer, just go to the thermostat and turn on the fan. If it works, the transformer is fine. It could be a relay that is your problem

the pilot light on gas furnace will not stay lit. after lighting i go to turn pilot to on, it goes out. why?

Feb 03, 2009 by tom | Posted in Maintenance & Repairs

thi furnace wasn't working, i found the pilot luminosity out. followed the directions to get it lit. the last thing you do is after it lights hold the reset button down for a minut then turn the knob to on. but when you do that it goes out.

It sounds like the hotness sensor is bad,however turn off the power and check wires for good contact and remove all dust, then try again.
t